|
This is a 2U module that mounts on the rear of my cabinets. It contains IEC connectors for AC in and AC out as well as fuses for each. These modules daisy chain the AC power between each cabinet so that a single power switch will control the entire synthesizer.
The module also contains a DC output connector with fuses for each of the voltage outputs so that I can power external modules. I install this connector on a few of the panels and plug the holes on the others. I use silicone sealant to cover all the primary connections and use spiral wrap on primary interconnect wiring. The plug connects to the power supply cable and the DC wiring connects to the MOTM-990 distribution board.
I mount the panel on the right rear of all the cabinets.
DJB-007 FrontPanelExpress design file